Grizzly Sander H2882 User Manual

MODEL H2882

7¹⁄2" PNEUMATIC DRUM

SANDER

INSTRUCTION SHEET

EYE/EAR INJURY HAZARD!

Wear safety glasses and

hearing protection during

use of this tool!

OVER INFLATION HAZARD!

Never exceed 8 PSI!

RESPIRATORY HAZARD!

Sanding produces fine

dust. Wear the appropriate

protection during use!

Figure 1. Model H2882.

Introduction

This rolling-pin style pneumatic drum sander is

perfect for hand contouring and smoothing proj-

ects that are too large to use with a stationary

sander. Simply chuck the ⁄8" spindle into a por-

table electric drill, cordless drill or air powered drill

for two-handed control. Choose this 7¹⁄2" x 2¹⁄4

diameter size for getting into tight areas. Features

ball bearing handle and air valve for easy bicycle

pump inflation.

Figure 2. Model H2882 in action.

7¹⁄2" Aluminum Oxide Sanding Sleeves

Inventory

A. Drum Sander.............................................. 1

B. Spare Valve Cap........................................ 1

H3881 2¹⁄4" x 7¹⁄2" x 60 Grit

H3882 2¹⁄4" x 7¹⁄2" x 100 Grit

H3883 2¹⁄4" x 7¹⁄2" x 150 Grit

H3884 2¹⁄4" x 7¹⁄2" x 180 Grit

H3885 2¹⁄4" x 7¹⁄2" x 220 Grit

H3886 2¹⁄4" x 7¹⁄2" x 320 Grit

Operation

Slide the sanding sleeve over the drum. Remove

the plastic cap on the handle with a small screw

driver to expose the air valve. Inflate to the desired

pressure. DO NOT exceed 8 PSI!

If you need help with your new pneumatic tool,

call our Tech Support at: (570) 546-9663.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#PC8029 PRINTED IN TAIWAN